Shibaura TF516MH-AB, Owner'S Manual

Page: 18 / 40

16
3. Handling of pump (Operating method)
○
Do not touch the ignition plug or high-tension cord during operation.
⚫ You may receive an electric shock.
○
During operation or immediately after operation, the exhaust pipe becomes
very hot. Never touch them
⚫ You may be burnt.
4. Stopping the engine
(1)
Set the throttle lever
②
to the “SLOW”
position.
○ If the engine is hot, cool it down by
continuing low speed operation for
about 1 minute.
(2)
Turn the water discharge valve lever in the
“
→
Close” direction and close the water
discharge valve.
(3)
Set the main switch
③
to the “Stop” position.
5. Draining the water
After the firefighting pump was operated, much water remains inside. If the water
is left in the pump, rust may be generated or the pump may be damaged due to
frozen water in the cold season. Be sure to drain water before storing the
firefighting pump.
(1)
After sea water or dirty water is used, be sure to keep clear water discharged
for more than 5 minutes.
(2)
Close the water discharge valve lever.
(3)
Open the pump drain cock, discharge the water completely and then close
the pump drain cock.
(4)
Screw in the cap of the water inlet.
(5)
Start the engine and pull the water suction lever for about 5 seconds.
(6)
Stop the engine.
(7)
Open the pump drain cock, release the vacuum and close the drain cock
again.
If the vacuum is not released, rubber of valves may be deformed shortening
its service life.
Caution
Caution