Sonnet Fuel Conversion
Kit -
50-1445 & 50-1446
Please read and understand these instructions before installing. Failure to follow these
instructions carefully could cause property damage or personal injury.
Warning: This conversion kit shall be installed by a qualified service agency in accordance with
the manufacturer’s instructions and all applicable codes and requirements of the authority
having jurisdiction. If the information in these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may result causing property damage, personal
injury or loss of life. The qualified service agency is responsible for the proper installation of
this kit. The installation is not proper or complete until the operation of the converted appliance
is checked as specified in the manufacturer’s instructions supplied with the kit.
Kit Parts List:
1 - Orifice (Natural Gas #42 DMS or Propane #54 DMS)
1 - Conversion label
1 - Installation instruction sheet
Carefully inspect the orifice supplied with this conversion kit. If it has been damaged or is missing, contact
your dealer, distributor or courier company to have them replaced before starting this installation. It is highly
recommended that you have your Sonnet Owner’s Manual with you to reference for this installation.
Conversion Kit Installation:
1. Shut the gas supply off at the
shut-off valve upstream of the unit.
CAUTION: The gas supply must
be shut off prior to disconnecting
the electrical power and before
proceeding with the conversion.
Allow the valve and unit to cool down
to room temperature.
Figure 1: Door Release.
Figure 2: Door Removal.
2. Remove the glass door by placing the hooked end of the door release
tool in the hole on the door latch mechanism (see Figure 1) and pulling
the latch out then up over the lip on the door. When the two (2) latches
have been released, tilt the door forward and then lift up to unhook the
bottom door tabs. (see Figure 2).
Figure 4: Burner Removal.
3. Carefully remove the log set and ember
material if they are installed.
4. Using a T-20 screwdriver, remove the four (4) screws that
hold the burner in place (pointed out in Figure 19). Slide
the burner to the left (see Figure 4), then up and out of the
firebox.
Figure 3: Unfastening Burner.