Main controller does not take part in such communication. Using this mechanism,
PIR may communicate with other devices even when the main controller is
damaged.
The status of LED
1.
when the
PIR
is triggered, LED light flashes red for 2 times.
2.
When the PIR installs battery, LED light will flash red for 2
times.
3.
Quickly, triple click the code button
,add the
PIR
to the Z-WAVE network or delete
PIR
from Z-WAVE network , LED light flashes red for 5 times.
4.
Press on the code button for 10 seconds, the
PIR
to restore factory settings, LED light
flashes for 1 times.
5.
In the normal condition, the LED light keeps being out.
Associations
This has the effect that when the sensor is triggered, all devices associated with the
sensor will receive the relevant reports. Through an association the sensor may
control another Z-Wave network device, e.g. the alarm device, wall plug, lamp etc.
This Sensor supports two association groups.
Association group 1
is assigned the status of the device status - send the BASIC SET
control frame to the associated to the associated devices having detected motion.
Association group 2
reports relay's status to just one device, Z-Wave network's main
controller by default. It's not recommended to modify settings of this association
group.
NOTE
Association allows for direct communication between Z-Wave network devices. Main
controller does not take part in such communication.
