05-62656-0B
Page 7
7. SecUre croSS
rAIlS WItH
clAMPS
6. InStAllInG coVer AnD croSS rAIlS
A.
Assemble Cross Rails by connecting each of the 6 remaining 12163 pipes to the 6 remaining 12164 pipes
(Fig. A).
B.
Lay the cover on the ground next to the frame with inside of the cover (the side with the pipe pockets) facing
down and the webbing on the front and rear of the corner of the building.
C.
Pull cover over the frame, making sure to center cover on frame. There should be an equal amount of over-
hang at all four corners.
D.
Insert the “S”- Hook on ratchet into hole on the leg bend (Fig. B). Insert the webbing into the spindle of
the ratchet and pull tight. Wind the ratchet so that the webbing overlaps itself (Fig. C).
E.
Slide the cover rails through fabric pockets at each leg and attach with clamps to each leg (See Step 7).
Repeat this on other side.
A
12164
12163
c
Thread Webbing Into Ratchet
note:
Check and tighten ratchets
and cover rails monthly.
B
10040
12163 12164
CROSS RAIL
10022
10023
01013
A.
Use 2 clamps at end of
each cross rail and hand-
tighten bolts (#01013).
B.
Push down on cross rails
to tighten cover, then tighten
bolts completely.
MIDDLE LEGS
CORNER LEGS
01013
01011
01011
01010
01010
