SHELF-MADE 0139-BK4 Installation Instructions Download Page 1

Installation Instructions

Ledge Shelving

0139-BK4 | 0139-HNY4

Tools Required (not included):

- Power Drill
- 1/8" Drill Bit or 1/4" Drill Bit
- Screwdriver
- Tape Measure
- Level

Installation Materials (included):

-  (4) Ledge Shelves
- Mounting Hardware

Load Rating:

-  20 lbs each shelf when mounted  

onto studs

Installation

:

STEP 1:

 Select the desired location for the shelf ledge.

STEP 2:

 Draw a line on the wall, using the level, in order to determine where the screw 

holes will be located. Measure the distance that will be required between the screws in 
order to mount the ledge shelf. Mark the positions of the screws in the desired locations, 
as shown in

 Figure 1

.

 

 NOTE:

 If the screws are being driven directly into a stud, pre-drill the screw holes using 

a 1/8" drill bit and drive the screws without using anchors, leaving 3/8" of each screw 
protruding from the surface of the wall, as shown in 

Figure 2

. (Skip to 

STEP 3

)

  

NOTE: 

If the screws are being driven into drywall and not into a stud, drill the screw 

holes using a 1/4" drill bit. Insert the anchors into the holes and drive the screws,  
leaving 3/8" of each screw protruding from the surface of the wall, as shown in

 Figure 3

.

STEP 3:

 Position the keyholes on the back of the ledge shelf over the screws. Pull the 

ledge shelf downward in order to secure it in place, as shown in 

Figure 4

.

STEP 4:

 If the ledge shelf is too loose, or if it does not fit over the screws properly, remove 

the ledge shelf and adjust the screws accordingly.

Measure Distance

(Back of Shelf)

Figure 1

Figure 4

Figure 2

Stud

3/8"

W

all Surface

Figure 3

3/8"

W

all Surface

2700 Oak Industrial Dr. NE

Grand Rapids, MI 49505

800-253-1561 

www.kv.com

[email protected]

©2015 Knape & Vogt. KV and the KV logo are trademarks of Knape & Vogt.        310455/0715

Reviews: