SHARX SECURITY HTNC Series, Api Reference Manual, Page: 85 / 228

-85-
Event – Light:
Version: 1.00e
Date: 2014. 03. 17
Revision History
Version Date Comment
1.00 2014-01-27 Initial version
1.00e 2014-03-17 English Translation
Introduction
This Chapter defines the detailed setup procedure for the Light.
Light URI
http://”camera ipaddress”/event/light.php
Light Parameter
Parameter Type Value
light_enable boolean 0 : Disable, 1 : Enable
light_level integer 1 ~ 10
light_mode integer
1 : light on until the end of Event In
2 : light on until the pre-defined time
light_time_select string second , minute : time unit
light_time integer 1 or 2 or 3 or … : Light time
light_night_enable boolean 0 : Disable, 1 : Enable
light_inactivate integer 1 : Off, 2 : Fade to off
* light_time, light_time_select, and light_night_enable are used only when Light_mode=2.
Examples
1) get the current setting
http://”camera ipaddress”/event/light.php?app=get
2) Light setup
http://”camera ipaddress”/event/light.php?app=set&light_enable=0
http://”camera ipaddress”/event/light.php?app=set&light_enable=1
3) Light brightness setup
http://”camera ipaddress”/event/light.php?app=set&light_level=1
http://”camera ipaddress”/event/light.php?app=set&light_level=5
http://”camera ipaddress”/event/light.php?app=set&light_level=10
4) Light mode & Light time setup
* In case of ‘Keep activate during event’, the light turns on for the duration of event in, and
light_mode=1.
* In case of ‘Keep activate for Time ’, the light turns on for setting time duration, which is
explained below, irrespective of event in duration, and light_mode=2.
* In case of ‘Operate only at night mode”, the light_mode=2 works only, and detail explanation is
in section 5).
* If the light_mode=2, the light turn on time duration is set via light_time and light_time_select.