Data is transferred in the same mode and directory.
If a transferred entry the exceeds the maximum number of
characters that can be entered into the EL series Organizer
as one entry, the excess characters are deleted.
Characters and symbols that cannot be displayed on the EL
series Organizer are replaced by spaces. If all the columns
that can be displayed are replaced by spaces, the
corresponding entry is not stored.
All letters are converted to capital letters on the EL series
Organizer.
If the SECRET function is turned on in the
only non-secret data can be transferred.
When transferring data from an EL
series Organizer
l
The received data is added to previously stored data.
l
All non-English characters are converted to small letters.
l
If the SECRET function is turned on in the EL series
Organizer, only non-secret data can be transferred.
Transferring data to an EL series Organizer
To transfer, for example, all TEL 1 data in
to
TEL 1 in the EL series Organizer,
1. Set the receiver in the receive mode.
2. Press (TEL) to select the TEL 1 directory on the transmitter.
3. Press
then 2 to select the data transfer function
on the transmitter.
Note: To transfer a single entry display the desired entry and
4.
.
press
2.
Press 1 to perform data transfer.
If the amount of memory available in the receiver at the
time of data transfer is insufficient, an error message
appears. Delete any unnecessary data, verify that there is
sufficient memory available, and repeat the procedure.
Transferring data from an EL series Organizer
1. Select the mode on the receiver.
2. Select the data transfer function on the receiver, and set it
in the receive mode.
3. Perform data transfer from the transmitter.
