44
Appendix
Specifications
Product type
Model
Video system
Display method
LCD panel
Lens
Projection lamp
Contrast ratio
Video input signal
S-video input signal
Horizontal resolution
Audio output
Computer RGB input signal
Computer control signal
Speaker system
Rated voltage
Input current
Rated frequency
Power consumption
Operating temperature
Storage temperature
Cabinet
I/R carrier frequency
Laser pointer of
“Power” remote control
Dimensions (approx.)
Weight (approx.)
Supplied accessories
Replacement parts
LCD Projector
XG-NV51XM
PAL/SECAM/NTSC 3.58/NTSC 4.43
LCD panel
3, RGB optical shutter method
Panel size: 22.9 mm (0.9
) (13.9 [H]
18.5 [W] mm)
Display method: Translucent TN liquid crystal panel
Drive method: TFT (Thin Film Transistor) Active Matrix panel
No. of dots: 786,432 dots (1,024 [H]
768 [V])
1–1.3
zoom lens, F1.7–2.0, f
33–43 mm
DC 180 W lamp
200:1
RCA Connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75
Ω
terminated
RCA Connector: AUDIO, 0.5 Vrms more than 22 k
Ω
(stereo)
4-pin mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75
Ω
terminated
C (chrominance signal): Burst 0.286 Vp-p, 75
Ω
terminated
580 TV lines (video input), 700 TV lines (S-video input)
2 W (monaural)
Video signal
15-
PIN
MINI
D-
SUB
CONNECTOR
(Computer Input Port 1, 2): RGB separate/composite
sync/sync on green type analog input: 0–0.7 Vp-p, positive, 75
Ω
terminated
S
TEREO
M
INIJACK
: AUDIO, 0.5 Vrms, more than 22 k
Ω
(stereo)
H
ORIZONTAL
SYNC
.
SIGNAL
: TTL level (positive/negative) or composite sync (Apple only)
V
ERTICAL
SYNC
.
SIGNAL
: Same as above
9-pin D-sub male connector (RS-232C Input Port)
3
3
⁄
32
(8 cm) round
AC 110–120/220–240 V
2.6 A/1.3 A
50/60 Hz
290 W
5°C to
40°C
20°C to
60°C
Plastic
40 kHz
Wave length: 670 nm
Max. output: 1 mW
Class
II
Laser Product
229
121
310 mm (W
H
D) (main body only)
243.5
128
346.4 mm (W
H
D) (including an adjustment foot and projecting
parts)
4.9 kg
“Power” remote control, Simple presentation remote control, Four AA size batteries, Two
AAA size batteries, Power cord (3 m), Computer cable (3 m), Computer audio cable
(3 m), Macintosh adaptor, Mouse control serial cable (1 m), Mouse control cable for
IBM PS/2 (1 m), Mouse control cable for Mac (17 cm), Remote mouse receiver, Extra air
filter, Lens cap (attached), Carrying bag, CD-ROM, LCD projector operation manual,
LCD projector quick reference, Sharp Advanced Presentation Software operation
manual, Sharp Advanced Presentation Software quick reference, IrDA driver installation
instruction sheet
“Power” remote control (RRMCG1471CESA), Simple presentation remote control
(RRMCG1480CESA), AA size batteries, AAA size batteries, Power cord, Computer
cable (QCNW-5108CEZZ), Computer audio cable (QCNW-4870CEZZ), Macintosh
adaptor (QPLGJ1512CEZZ), Mouse control serial cable (QCNW-5112CEZZ), Mouse
control cable for IBM PS/2 (QCNW-5113CEZZ), Mouse control cable for Mac (QCNW-
5114CEZZ), Remote mouse receiver (RUNTK0661CEZZ), Air filter (PFILD0076CEZZ),
Lens cap (GCOVH1307CESB), Carrying bag (GCASN0001CESA), CD-ROM
(UDSKA0014CE01), LCD projector operation manual (TINS-6795CEZZ), LCD projector
quick reference (TINS-6942CEN1), Sharp Advanced Presentation Software operation
manual (TINS-6671CEN1), Sharp Advanced Presentation Software quick reference
(TINS-6943CEZZ), IrDA driver installation instruction sheet (TCAUZ3051CEZZ)
This unit has some inactive TFTs within acceptable tolerances which
may result in illuminated or inactive dots on the picture screen. This
will not affect the picture quality or the life expectancy of the unit.
This SHARP projector uses LCD (Liquid Crystal Display) panels. These
very sophisticated panels contain 786,432 pixels (
RGB) TFTs (Thin
Film Transistors). As with any high technology electronic equipment
such as large screen TVs, video systems and video cameras, there
are certain acceptable tolerances that the equipment must conform
to.
Specifications are subject to change without notice.
