16
Operation
Operation
Basic Operations
1
Make the necessary connections before pro-
ceeding. Connect the power cord to a wall outlet.
The POWER indicator lights up red and the
projector enters standby mode.
• If the bottom filter cover is not securely installed, the
POWER indicator flashes.
2
Press
Power ON
.
• The flashing green LAMP REPLACEMENT indicator shows
that the lamp is warming up. Wait until the indicator stops
flashing before operating the projector.
• If the power is turned off and then immediately turned on
again, it may take a short while before the lamp turns on.
• If the keylock level is set to “Level A” or “Level B”,
Power
ON
and
Power OFF
can only be used on the remote
control. (See page 41.)
• After the projector is unpacked and turned on for the first
time, a slight odour may be emitted from the exhaust vent.
This odour will soon disappear with use.
2
When the power is on, the LAMP REPLACEMENT
indicator lights indicating the status of the lamp.
Green:
Lamp is ready.
Flashing green:
Warming up.
Red:
Change the lamp.
