Sharp MX-M350-N, Operation Manual, Page: 65 / 228

3-7
3
FINISHER
The finisher can deliver collated sets either stapled or unstapled. Unstapled sets can be offset stacked from the
previous set for easy separation of the sets.
Part names
Specifications
Specifications are subject to change for improvement without notice.
Supplies
AR-SC1 staple cartridges must be used for this finisher. The cartridge
package contains three cartridges approx. 3000 staples each.
NOTES
●
Do not put pressure on the finisher (particularly each tray).
●
Do not place anything on the top cover. Doing so will interfere with the machine’s paper handling during duplex printing.
●
The tray moves up and down during operation. Be careful not to impede its movement.
●
The finisher requires the installation of other peripheral devices in order to be functional and cannot be installed
together with some other devices. The table on page 8-4 shows the configurations which are compatible.
Name Finisher (AR-FN6)
Number of trays 2
Paper output Print face down
Tray type Top tray: normal tray, Lower tray: offset tray
Tray capacity
Top tray: 500 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80
g
/m
2
)
Lower tray: 750 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g /m
2
)
Paper sizes
Top tray: same as the specifications of paper for feeding in the main unit
Lower tray: Max. 8-1/2" x 11" or A4, Min. B5
Paper weight
Top tray: same as the specifications of paper for feeding in the main unit
Lower tray: 16 to 34 lbs. or 60 to 128
g /m
2
Paper types
Top tray: same as the specifications of paper for feeding in the main unit Lower tray:
plain paper only
Tray full detection Provided in both the top tray and the lower tray
Offset function Provided for the lower tray only. The offset amount is approx. 1 inch (25 mm)
Paper sizes for stapling 8-1/2" x 11", A4, and B5
Stapling capacity
30 sheets* (8-1/2" x 11" or A4 or smaller 20 lbs. or 80
g
/m
2
)
*Up two sheets of cover stock (34 lbs. or 128 g /m
2
) can be included.
Staples
Single staple can be placed in the top left or lower left corners or two staples can be
centered on the left side
Power supply Supplied from machine
Dimensions
18-5/8"* (W) x 20-7/8" (D) x 20" (H) (473 mm* (W) x 530 mm (D) x 508 mm (H))
* When the top tray is extended.
Weight Approx. 46.3 lbs. (21 k g )
Latch
Release the latch to open the
finisher for misfeed removal.
Pull the box out to
replace the staple
cartridge or to
remove jammed
staples.
Staple box
Printer, copier and fax
output can be delivered
here.
To print onto large paper
(11" x 17", 8-1/2" x 14",
8-1/2" x 13", A3 or B4),
extend the tray.
Top tray
Top cover
Open for misfeed
removal.
Offset tray
Stapled sets or sets to be
offset will be delivered
here.
Copy_SEC.book 7 ページ ２００６年１２月１３日 水曜日 午後３時１分