Sharp MX-M266N, Operation Manual

Page: 83 / 794

1-42
BEFORE USING THE MACHINE
Contents
PLACING THE ORIGINAL ON THE DOCUMENT GLASS
This section explains how to place the original on the document glass.
Allowed ori g inal sizes
When the original is a non-standard size, see the
appropriate explanation below for the mode you are
using.
+
2. COPIER " SPECIFYING THE ORIGINAL SIZE "
(page 2-27)
+
4. FACSIMILE " IMAGE SETTINGS " (page 4-45)
+
5. SCANNER / INTERNET FAX " IMAGE
SETTINGS " (page 5-53)
Maximum ori g inal size
Standard sizes
11" (height) x 17" (width)
A3: 297 mm (height) x 420 mm (width)
Non-standard sizes
11-5/8" (height) x 17" (width)
297 mm (height) x 432 mm (width)
1
Open the automatic document feeder.
2
Place the ori g inal.
Place the original face down in the far left corner of the
document glass.
The ori g inal should always be placed in the far left corner,
re g ardless of its size.
Align the top left corner of the original with the tip of the mark.
If you are placing a small non-standard size original on the document glass, it is convenient to place a blank sheet of
8-1/2" x 11" or 5-1/2" x 8-1/2" (A4 or B5) paper on top of the original to facilitate detection of the original size.
3
Close the automatic document feeder.
After placing the original, be sure to close the automatic
document feeder. If left open, parts outside of the original will
be copied black, causing excessive use of toner.
8-1/2" x 11"R (A4R)
B5R
8-1/2" x 14" (B4)
11" x 17" (A3)
8-1/2" x 11" (A4)
5-1/2" x 8-1/2"
(A5)
B5
mark
Document g lass scale
Document g lass scale
mark