Sharp MX-M266N, Operation Manual

Page: 763 / 794

8-16
TROUBLESHOOTING
Contents
Printin g does not take
place.
Was a Notice Page printed? Check the printed Notice Pa g e.
A Notice Page will be printed to indicate the cause of the
problem if a print job cannot be performed as specified
and the cause is not shown in the display. Read the
printed page and take appropriate action.
For example, a notice page will be printed in the
following situations.
• The print job is too large to fit in memory.
• A function that has been prohibited by the
administrator is specified.
By factory default, Notice Pages are not printed.
Have functions been disabled by the
administrator? Check with your administrator.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Two-sided printin g
does not take place.
Does the paper type setting of the
selected tray specify a type of paper that
cannot be used for two-sided printing? Check "Tray Settin g s" in the system settin g s.
If the [Disable Duplex] checkbox is selected ,
two-sided printing using that tray will not be possible.
Change the paper type setting to a type that can be
used for two-sided printing.
Þ
System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change"
Are you using a special size or type of
paper? For the paper types and sizes that can be used for
two-sided printin
g , see "SPECIFICATIONS" in the
Start Guide.
Have functions been disabled by the
administrator? Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Direct printin g of a file
in a shared folder on a
computer is not
possible.
Is "IPsec Settings" enabled on the
machine? Check with your administrator.
When "IPsec Settings" is enabled in the system settings
(administrator), direct printing of a file in a shared folder
may not be possible in some computer environments.
Þ
System Settings (Administrator) > "Security Settings"
> "IPsec Settings"
A tray, finisher, or
other peripheral
device installed on the
machine cannot be
used. Have the peripheral devices that are
installed on the machine been
configured in the printer driver? Open the printer properties and click the [Auto
Confi
g uration] button on the [Confi g uration] tab.
(Windows)
If auto confi
g uration cannot be executed, see the
Software Setup Guide.
Problem Point to check Solution