Sharp MX-C507P, User Manual

Page: 174 / 182

Power consumption
Product power consumption
The following table documents the power consumption characteristics of the product.
Note: Some modes may not apply to your product.
Mode Description Power consumption (Watts)
Printing The product is generating hard
‑
copy output from electronic inputs. One-sided: 680
Two-sided: 570
Copy The product is generating hard
‑
copy output from hard
‑
copy original
documents.
N/A
Scan The product is scanning hard
‑
copy documents. N/A
Ready The product is waiting for a print job. Higher power usage: 80
Lower power usage: 45
Sleep Mode The product is in a high
‑
level energy
‑
saving mode. 2.23
Hibernate The product is in a low
‑
level energy
‑
saving mode. 0.3
Off The product is plugged into an electrical outlet, but the power switch
is turned off. 0.2
The power consumption levels listed in the previous table represent time-averaged measurements.
Instantaneous power draws may be substantially higher than the average.
Sleep Mode
This product is designed with an energy-saving mode called Sleep Mode . The Sleep Mode saves energy by
lowering power consumption during extended periods of inactivity. The Sleep Mode is automatically engaged
after this product is not used for a specified period of time, called the
Sleep Mode Timeout .
Factory default Sleep Mode Timeout for this product (in minutes): 15
By using the configuration menus, the Sleep Mode Timeout can be modified between 1 minute and 120 minutes.
If the print speed is less than or equal to 30 pages per minute, then you can set the timeout only up to 60
minutes. Setting the Sleep Mode Timeout to a low value reduces energy consumption, but may increase the
response time of the product. Setting the Sleep Mode Timeout to a high value maintains a fast response, but
uses more energy.
Hibernate Mode
This product is designed with an ultra
‑
low power operating mode called Hibernate mode . When operating in
Hibernate Mode, all other systems and devices are powered down safely.
The Hibernate mode can be entered in any of the following methods:
•
Using the Hibernate Timeout
•
Using the Schedule Power modes
Notices 174