7-21
Rcv. Function
These settings are used to change the default settings
(initially set at the factory) for the various fax reception
functions to settings that better meet your needs.
Select the [Rcv. Function] to configure the settings.
#Of Rings At. RX
When the reception mode is set to auto, this setting is
used to select the number of rings on which the machine
automatically receives a call and begins fax reception.
(See
.)
• Any number of rings from 0 to 15 can be selected.*
Normally "2" is selected.
• If you make a mistake, move the cursor to the mistake
with the [
] [
] keys and reenter.
#Of Rings Man.RX
(This function may not be available in some regions)
You can set the number of rings on which the machine
changes to auto reception when there is an incoming fax
call in manual reception mode.
Tray Selection
This setting is used to select which output trays can be
used for received faxes. All output trays are initially
enabled.
• The selected tray is enabled and a checkmark
appears in the checkbox.
• If this procedure is performed when the tray is
enabled, the checkmark will be cleared and the tray
disabled.
Received Data Print Condition
This setting determines the selection condition for paper
when printing received documents. Select one of the
three conditions below. "Reduction" is normally selected.
• Reduction
Each received image is printed at actual size when
possible. When not possible, the image is
automatically reduced before printing.
• Division
Each received image is printed at actual size.
If necessary, the image is split onto multiple sheets of
paper.
• Actual Size
The received fax image is printed at its actual size
(without dividing it onto multiple sheets of paper).
If the same size of paper or larger paper is not loaded,
the fax will be received in memory and will not be
printed until a suitable size of paper is loaded.
Auto Rcv Reduce To Regular Size
When you receive a fax that includes the sender's name
and number, the received image is slightly larger than
the standard size*. This setting lets you select whether
or not the received image is automatically reduced
before printing to fit the standard size. Normally this
setting is enabled.
*Standard sizes are sizes such as 8-1/2" x 11" and
5-1/2" x 8-1/2".
Duplex Reception
This setting is used to select whether or not received
faxes are printed on both sides of the paper. When
two-sided printing is enabled and a fax that is two pages
or longer is received (the pages must be the same size),
the fax will be printed on both sides of the paper.
Even if the pages are in different orientations, the pages
are rotated appropriately to enable printing on both sides
of the paper.
• The setting is enabled (two-sided printing will take
place) and a checkmark appears in the checkbox.
• If the procedure is performed when the setting is
enabled, the checkmark will be cleared and the setting
disabled.
• If the number of rings is set to 0, the machine will
receive faxes without ringing.
• When the number of rings is set to 14 or 15,
reception may not be possible depending on the
functions and settings of the other machine.
• The trays that can be enabled will vary depending
on the options that are installed.
• The trays cannot all be disabled.
• If this setting is disabled (no reduction) and the
received data print condition is set to division, the
image may be clipped.
• If auto receive reduce is disabled, an image larger
than the standard size will be cut off. However, the
image will be clearer because it will be printed at the
same size as the original.
Summary of Contents for MX-B350W
Page 306: ...2018D US1 ...
