Sharp MX-2640N, Technical Manual

Page: 51 / 71

SHARP
TEST SIMULATION
51
66
Fax Control Settings & Adjustments
1 Fax Soft SW setting:-
SW27-6 V.34 mode function (manual
communication):-
0 = V.34 valid.
1 = V.34 invalid.
SW33-6,7 Transmission cable amplitude
equaliser:-
00 = 0dB
01 = 4dB
10 = 8dB
11 = 12dB
2 Country code default set (Fax)
3 Fax PWB controller memory check
4 Fax signal line check (Max level)
5 Fax signal line check (Soft SW setting level)
6 Fax list print (confidential registration)
7 Fax memory printout (all data)
8 Fax sound message setup
9 Fax signal line check (Soft SW setting)
10 Fax all memory clear
11 Voice signal check (line/speaker 300bps)
12 Voice signal check (line/speaker 300bps)
13 Register dial number for Sim 66-14/15/16
14 Adjust/check the time dial pulse (10bps)
15 Adjust/check the time dial pulse (20bps)
16 Adjust/check the send level DTFM signal
17 DTFM signal to send to line (Max level)
18 DTFM signal to send to line (Soft Sw level)
21 Print various registration information
22 Set the sound volume of the handset
24 Fast memory data clear
29 Fax address book clear
30 Tel/LIU sensor status check
31 ON/OFF setting of output port (Tel/LIU)
32 Received data check (comparison)
33 Busy Tone/CNG/CED/FNET detect check
34 Display time required for sending test data
36 Check Send/Receive from modem.
39 Check Destination saved in Fax EEPROM
42 Rewrite PIC program installed on Fax box
43 Write program & adjustment values to PIC
installed on Fax
61 Display FAX related soft switch (151-250)
62 FAX receive data export in PDF format.
67
Printer Settings & Adjustments
17 Printer NVRAM clear
24 Printer half tone auto adjustment
25 Printer half tone colour adjustment
26 Standard target select of printer half tone
auto adjustment
27 Scanner target of printer calibration setup
(Service)
28 Standard target of printer colour
calibration (Service)
31 Printer calibration data clear
33 Printer screen gamma adjust. (PCL/PS)
34 Engine maximum adjustment mode for
printer
36 Adjust low density section
41 Threshold value setting for printing
judgement of the black colour in B/W
printing or selected colour.
42 Gradation setting amount for the black
colour in B/W printing or selected colour.
43 Colour balance adjustment of fine B/W
printing.
45 Printer image filter and trapping
adjustment.
52 Printer default gamma check (PCL/PS)
54 Printer colour balance adjustment