MX-3114N VARIOUS STORAGE DATA HANDLING 11 – 3
2. Necessary steps when replacing the PWB, HDD and the SD Card
A. MFP substrate replacement procedure (work flow)
Registered user information will not be recovered if the MFP PWB is affected by U2-05 trouble. (*1)
1)
Attach the flash ROM, the memory, the EEPROM, the SD card etc. of the MFP PWB on the service parts MFP PWB and install it to the
main unit.
Ground your body with grounding band during the work.
2)
When U2 trouble occurs, use SIM16 to cancel it.
3)
Set as follows after restarting the main unit.
At this timing, F6-21 may occur. Whether it may occur or not, go to execute procedure 1.
(1) Set the appropriate country code by Sim66-02 (clear the software switches related to FAX).
Make sure to execute even if the fax option is not installed on the machine.
B. Procedures necessary for HDD replacement
Note for HDD replacement
• Data of the following list are saved in the HDD of the complex machine. If the HDD operates normally and data backup is possible before
replacement, perform data backup and then replace the HDD.
• If the HDD does not operate normally, data cannot be backed up.
• The HDD replacement procedures with a broken HDD differs from that with a normal HDD.
Contents of this chapter
• HDD storage data and backup
• Replacement procedures when HDD storage data can be backed up
• Replacement procedures when HDD storage data cannot be backed up due to breakdown of HDD
• Reinstall and update procedures of Operation Manual data saved in HDD
• Reinstall and update procedures of watermark data.
