Sharp MX-1100, User Manual, Page: 391 / 655

71
Specifying the original scan size (by paper size)
If you place a non-standard size original or wish to change the scan size, you must touch the [Original] key and specify
the original size manually. Follow the steps below after placing the original in the document feeder tray or on the
document glass.
1
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
(2) Touch the [Original] key.
The automatically detected original size appears to the right of the [Original] key.
☞
IMAGE SETTINGS (page 68)
2
Touch the [Scan Size] key.
3
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 31-1/2" (800 mm) (the maximum height is 11" (297 mm)).
• When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. Scanning will take
place in mono2.
• To specify an AB size for the scan size, touch the [AB Inch] key to highlight the [AB] side and then specify the
scan size.
4
Touch the [OK] key.
Scan / Original
OK
Auto
Auto 8 ½ x11
Scan Si z e
2-Sided
Tablet 2-Sided
Booklet
Send Si z e 100%
Image Orientation
Scan / Original
OK
Auto
5 ½ x8 ½
5 ½ x8 ½ R
8 ½ x11
8 ½ x11R
8 ½ x1 3 (216x 33 0)
11x17
8 ½ x14
Si z e Input
Long Si z e
Inch
AB
Manual
Manual
8 ½ x1 3 (216x 3 40) 2
5
(2) (1)
Scan / Original
OK
Auto
5 ½ x8 ½
Scan Si z e
2-Sided
Tablet 2-Sided
Booklet
Send Si z e 100%
Image Orientation