Sharp LL-T1811, Operation Manual

Page: 29 / 144

29
English
8 ~ 10 mm
Screw used to attach arm
Arm
Part of monitor to which
arm is attached
Instructions for attaching a VESA compliant arm
An arm or stand based on the VESA standard
(purchased separately) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.
Arms or stands able to be used
Attachments must satisfy the following.
- Compatible with the VESA standard
- Have a gap of 100 mm x 100 mm between the
screw holes on the section to be attached
- Not be likely to fall off or break off after being
attached to the monitor.
How to attach the arm or stand
Note:
-
Do not bend the signal cable or the AC adapter
cable nor place weight on them. Doing so could
lead to damage.
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand
1. Spread out a soft cloth on a suitable horizontal
surface.
2. Being careful not to damage the monitor, gently
lay the monitor on it display-side down.
3. Remove the stand cover and the covers to the
left and to the right.
4. Remove the two screws, and remove the cover.
5. Remove the four screws and then remove the
stand from the monitor.
6. Attach the arm to the monitor with the four
screws.
CAUTION!
Be careful not to cut or jam your fingers.
The screws used to attach the arm should be M4 screws
with a length of 8 mm ~ 10 mm protruding from the
surface to be attached.
Using different screws could lead to malfunction or may
lead to the monitor falling off,internal damaged,personal
injury
Four screws
Stand
Cover
Two screws
(Rear view)
Stand cover
Lift one side
Cover
Cover