45
LC-55LB481U 55" Full HD LED 1080p Sharp Roku TV
Scanning for channels can take several minutes.
Now, you’re ready to watch broadcast TV! While you're watching, try the following:
• Press the
UP
and
DOWN
arrows to change channels.
• Press the
LEFT
arrow to display the channel list and then use the
UP
and
DOWN
arrows to select a channel to watch. Or
press
REWIND
or
FAST FORWARD
to jump through the channel list a page at a time.
• Press
OK
to display information about the current program.
• Press
to switch to the previously tuned channel.
• Press to see options for picture and sound settings.
Using your TV
This section provides information on using the day-to-day features of your TV.
Status light
Your TV has a single status light on the front panel. It goes on and off and blinks in different ways depending on the status of
the TV, as shown in the following table:
Tip
Repeat the channel scan from time to time to make sure you are receiving all of the
latest channels. Broadcasters add and remove channels, move channels to different
parts of the spectrum, and change the power levels of their channels periodically.
Note
You’ll have to repeat the channel scan if you remove the
Antenna TV
tile from the
Home
screen or perform a factory reset. To repeat the channel scan at any time, go to
Settings > TV inputs > Antenna TV > Scan again for channels
. Your antenna
reception and picture quality depend on the position of your antenna and on your
location relative to the antennas of broadcasters in your area.
Note
If
is not available on your remote control, you can use
on the Roku App or the
Jump Back button on a universal remote. For more information, see
on
page
.
on page
has more information on using the remote control
buttons while watching TV.
TV condition
Status indicator
Meaning
On (screen is active)
Off
Screen is indicating that your TV is on.
Screensaver (screen is active,
except when the
Picture
Mode
is set to
Low power
.
Low power
turns off the
backlight.)
Off
Screen is indicating that your TV is on.
Off (no power)
Off
Your TV is not connected to power.
Off (standby)
On
Your TV is connected to power and ready
to use.
Starting up from off state
Slow pulsing blink until
startup completes
Your TV is doing something.
On (receiving update from
USB)
Slow pulsing blink until
update completes
Your TV is doing something.
Remote control command
received
Dims on/off once
Your TV has received your command.
Powering down to standby
mode
Slow pulsing blink until
the TV reaches standby
Your TV is doing something.
Sharp LC-55LB481U_16-0752_MAN_V2_EN.book Page 45 Friday, November 4, 2016 3:00 PM
