Sharp LC-32HT1U, Service Manual

Page: 9 / 61

9
LC-32HT1U
TV (rear view)
Setting the
TV
Preparation
Connect the AC plug for the TV into the power outlet.
1 3
Remove the terminal covers on the rear of the TV. Place the ferrite core in the space indicated in the below figure and bundle the cords properly with a cable clamp and cable tie.
CAUTION
•
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE AC CORD CONNECTED.
Press down the upper hooks to remove the covers toward you.
2
Attach your antenna to the back of the TV.
4
To power outlet
NO
TE
•
The TV can be swiveled 10 degrees right and left with TV stand attached.
•
You cannot tilt the screen vertically.
AC cord
Preparation
! "#"
! "#"
$ %
&
"
'
(
$
%
$
%
) *
)(
$ %
Cable without a CATV
converter
Combination
VHF/UHF antenna
Separate VHF/UHF
antenna
Connecting Antenna Cable
+,
"
)$)
)
*$
!$(
) $
)
$
% ,
-,
"
)$)
)
. /
*
'
(
$
% ,
!$(
!$(
When connecting the RF cable to the TV set, do not tighten F-type connector with tools. If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)
F-type connector should be finger-tightened only.
NO
TICE
Antennas
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector
,
plug it into the antenna terminal at the rear of the TV set.
Connecting to the PPV terminal bo
x
Connect the TV and the PPV terminal box as shown.
RJ-11 cable (supplied by Pay Per View provider)
Coaxial cable (commercially available)
To
power outlet
To
room antenna terminal
PPV terminal bo
x
Hotel server
Connection f
o
r
a c
lear digital signal
Signal splitter
(commer
cially available)