E – 3
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, and the feature sticker from the outside of the door, if there
is one. Check the unit for any damage, such as a misaligned door, damaged door seals around the door or
dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven until it has
been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Rack 2) 2 Baking trays 3) Operation manual
3. Since the door may become hot during cooking, and in order to avoid its accidental touch, the oven should be
placed at least 85 cm or more above floor. You should also keep children away from the door to prevent them
burning themselves.
4. This oven is designed to be used on a countertop only. It should not be installed in any area where excessive
heat and steam are generated, for example, next to a conventional oven unit. It should not be installed near
combustible materials, for example, curtains. The oven should be installed so as not to block ventilation openings.
A fire may occur if this appliance is covered or touching flammable material, including curtains, drapes, walls,
etc. Allow space of at least 13cm from top of the oven for air ventilation. This oven is not designed to be built-in
to a wall or cabinet.
WARNING: Steam is ventilated from the top rear of the oven. Make sure the escaping steam does not
wet electrical outlets/other electrical appliances.
5. If the window is close to the oven, keep more than 20 cm distance between the ventilation and the window.
Window may be broken by the heat from the ventilation.
CAUTION:
Steam ventilated from the oven may wet or dirty nearby furniture or wall. Keep sufficient
space between the oven and the wall or furniture. Steam comes from the ventilation cover or door during
cooking or after cooking. Steam may be condensed on the wall or furniture around the oven. Install the
oven where it can be well ventilated.
To prevent from wet, we recommend to cover the wall or furniture with aluminium foil.
6. Do not connect other appliances to the same socket using an adaptor plug.
7. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure. The A.C. voltage and frequency must
correspond to the one indicated on the rating label.
8. This appliance must be earthed:
IMPORTANT
The wires in power supply cord are coloured in accordance with the following code:
Green-and-yellow : Earth
Blue
: Neutral
Brown
: Live
As the colours of the wires in the power supply cord of this appliance may not correspond with the coloured
marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured
blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured brown.
When unpacking your Water Oven, you may notice a small amount of water inside
the oven and water tank.
This is a normal phenomenon of testing.
(AX-1700R).indb 3
2019/08/01 15:32:11
