AR-NC5J/NC5JG/NC5JW - 2
2. Jumper switches
The jumper switch has No. 1 and No. 2 pins, and ON/OFF is switched
by the jumper plug.
When getting started, No. 1 pin is ON and the flash memory loader is
started. When No. 2 is ON, the factory setting of the environmental
variable is performed.
NOTE:
• When setting the jumper switch, be sure to turn off the power of the
printer.
• For normal use, be sure to set No. 1 and No. 2 to OFF (Normal
mode).
• The factory setup can be set by the utility or Telnet as well as the
above jumper switch setup operations. Normally the utility or Telnet
is used. Setting by the jumper switch is used only when the unit can-
not make communication with the AR-NC5J.
[5] INSTALLATION
1. Connection to a network
To connect the AR-NC5J to a network, the following items are required.
• For connection in the 100BASE-TX environment, a hub conforming
to 100BASE-TX and a shield-type, twisted-pair cable (Category 5)
are required.
1) Check that the printer power is off, and connect the shield-type,
twisted-pair cable to the 10/100BASE connector of the AR-NC5J.
2) Connect the other end of the cable to the hub.
3) Turn on the printer power, and check that the printer operates nor-
mally.
2. Parts included
3. Installation procedure
The AR-NC5J installing procedures in the AR-235/275 series are
described.
In this case, no spacer is used in the packed items of the AR-NC5J.
For the installing procedures of the AR-NC5J to another printer, refer to
the printer's Service Manual or Installation Manual.
Turn off the main switch of the copier and then remove the power
plug of the copier from the outlet.
1) Remove the shielding plate.
Remove five screws and remove the shielding plate.
2) Cut and remove the cut-out portion from the left rear cabinet.
Cut and remove the cut-out portion from the left rear cabinet using
a tool such as nippers. (Be careful about the direction of the tool so
that the cut surface is flat.)
Jumper witch
ON
OFF
1
Forcible loader mode Normal mode (When shipping)
2
Factory setup mode
Normal mode (When shipping)
Normal mode
(When shipping)
Forcible loader mode
Factory setup
Hub
Shield-type, twisted-pair cable
1 2 3 4
10BASE-T/
100BASE-TX
connector
Jumper switch
1
2
Jumper plug
1
2
1
2
1 2
3 4
5
6 7
8
Print server card: 1
Screws (silver)
M3 x 8: 2
Spacers (unused): 2
CD-ROM: 1
Operation manual: 1 Installation manual: 1
Screws
Cut-out portion
