26
21HS-50N
Service precaution:
The area enclosed by this line is directly ( )
connected with AC mains voltage.
When servicing the area, connect an insolating
transformer between TV receiver and AC line to
eliminate hazard of electric shock.
Waveform measurement condition:
Colour bar genetator signal of 70 dB from RF input.
Description of Schematic Diagram
1. The unit of resistance «ohm»is omitted (K=1000 ohms.
M= Megaohm).
2. All resistors are 1/16 watt. unless otherwise noted.
3. All capacitors are
µ
F, unless otherwise noted (P=
µµ
F).
4. The capacitor with Part No. RC-FZ9XXXBMNJ is
designed to with stand 63V.
5. The capacitor with Part No. RC-FZ4XXXBMNJ is
designed to with stand 50V.
Note:
CAUTION
This circuit diagram is original one, therefore
there may be slight difference from yours.
Important safety note:
Parts marked with «
» (
) are important
for maintaining the safety of the set. Be sure to
replace these parts with specified ones for
maintaining the safety and performance of the set.
!
Safety note:
1. Disconnect the AC plug from the AC outlet before
replacing parts.
2. Semiconductor heat sinks should be regarded
as potential shock hazards when the chassis is
operating.
WAVEFORMS
SCHEMATIC DIAGRAM
Summary of Contents for 21HS-50N
