MEDIA READER IV USB 3.0
4
2.2 General
Type:
Internal
Max. Data Transfer Rate:
5 Gbit/s
Connector:
Internal USB 3.0 (19-Pin)
Cable Length:
50 cm
Chip:
Realtek RTS5301
Weight incl. Cable:
254 g
Dimensions (L x W x H):
120 x 101 x 25 mm
2.3 System Requirements
Housing with available internal 3.5” or 5.25” drive bay
USB 3.0 port (19-pin) for the mainboard
Supported operating systems: Windows 7/8/10
3. Package Contents
Media Reader IV USB 3.0
5.25" mounting frame
Mounting screws
Manual
Note:
If you are missing any of the items listed above, please contact our customer service immediately:
[email protected] (Germany and Europe)
[email protected] (International)
4. Installation
Media Reader IV USB 3.0 may be mounted in either a 3.5" or a 5.25" drive bay. For installation in a 3.5" bay,
remove mounting frame first.
1. Turn off your PC and unplug the power cord.
2. Open the PC case.
3. Remove the front panel of the 3.5" drive bay and slide the Media Reader IV into the drive bay.
4. Attach the Media Reader IV inside the drive bay using the included screws on both sides.
5. Connect the Reader’s USB cable to a USB port on the mainboard and the 4-pin IDE plug with matching conn-
ector of your power supply.
6. Close the PC case, re-attach the power cord and start your PC.
All necessary drivers will be installed automatically. After that, your device is ready to use.
Note:
Your Media Reader IV USB 3.0 supports hot-swap. Memory cards may be inserted or removed at any time. Data
transfer from one memory card to another is also supported. To avoid data loss, do not remove memory cards
while reading or writing is in progress.
