6
IMPORTANT:
Your Steam Mop needs
water to make steam! Never use
your Steam Mop without water in the
tank.
Sweep or vacuum your floors
before using your Steam Mop. Your
Steam Mop was designed to get
rid of stuck-on gunk, grime, paw/
footprints and it will do a better job
if yesterday’s cereal crumbs aren’t in
the way.
Using Your Steam Mop
1
Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug into a 220-240
volt electrical outlet. The “On” light
will turn green. Success! If your
light doesn’t turn on reference the
Troubleshooting section on page 9.
2
For your comfort, you can adjust the
height of the mop. Just lift the latch
on the tube 90 degrees to the open
position. Holding the handle, extend
the tube to the height that’s right for
you and then close latch to locked
position.
Now comes the part you’ve been
waiting for – it’s time to use your steam
mop. When you use your steam mop
for the first time or haven’t used the unit
in awhile, it may take a minute or two
for the water to make its way through
the pump and into the heater to create
steam. Get it started by pumping the
handle a few times. If you’ve waited a
few minutes and you still don’t see any
steam, reference the troubleshooting
section on page 9.
1
2
S3101UKJR_IB_ENG_100729.indd 6
10-07-30 9:43 AM
