11
s h a r kc l e a n . c o m
10
s h a r kc l e a n . c o m
The Shark® Pro Steam Pocket® Mop has two unique steam settings so you can use the perfect
amount of steam for the cleaning task at hand. See below for tips on when to use each setting.
USING YOUR STEAM MOP - CONT’D
fig. 8
fig. 10
fig. 9
SELECTING A STEAM SETTING
3
For quick dusting and drying, use the
DUST setting. Press the steam control
button once to select DUST.
(fig. 8)
For
normal everyday steam cleaning, press
the steam control button again to select
the MOP setting.
(fig. 9)
When you are using the mop for the
first time, it might take longer than the
normal 30 seconds to start steaming.
To better understand which steam setting
to use for each cleaning task, refer to the
Settings chart on page 11.
4
Clean your floors with a forward and
backward motion.
(fig. 10)
To stop the
steam, press the steam control button
until it flashes.
SETTINGS
IDEAL FOR THESE SURFACES
RECOMMENDED USAGE
DUST
Laminate
Bamboo
Hardwood
Marble
Light cleaning and dusting
Loosening and removing light dirt
MOP
Hardwood
Marble
Tile
Stone
Linoleum
Basic, everyday steam cleaning
Removing spots and smaller messes
Cleaning moderately or heavily
trafficked areas
Sanitizing floors*
TO SANITIZE* WITH THE RECTANGLE MOP HEAD:
1
Start with a clean pad.
2
Follow instructions in the Using Your Steam Mop section.
3
Wait for the unit to begin producing steam.
4
Start mopping on an appropriate sealed hard-floor surface with a forward and backward
motion.
5
After three minutes, your unit will be ready to sanitize.
6
Using a forward and backward motion, move the unit slowly and evenly over the area to be
sanitized.
7
Repeat at least 15 times.
*Sanitization studies were conducted under controlled test conditions. Household conditions
and results may vary.
IMPORTANT: DO NOT
use the Steam Mop without attaching a Dirt Grip® pad and adding
water to the water tank first. When you are using the Steam Mop for the first time, it might
take longer than the normal 30 seconds to start steaming.
IMPORTANT: DO NOT
use on unsealed wood or unglazed ceramic floors. On surfaces that
have been treated with wax and on some unwaxed floors, the sheen may be removed by the
heat and steam action. Test an isolated area of the surface to be cleaned before proceeding,
and follow the use and care instructions from the floor manufacturer.
