ENGLISH
12
13
sharkclean .com
MAINTENANCE
STORAGE
Fig.
17
Upper
Cord Hook
Lower
Cord Hook
STORE YOUR VACUUM SAFELY
1
Convert your vacuum back to upright
mode�
2
Rotate the upper cord hook to its upright
position and coil the power cord loosely
around the two cord hooks� Clip the plug
onto the cord to secure�
(Fig� 17)
3
Store the dusting brush and the crevice
tool on the mounts on the accessory
holder�
Fig.
18
Fig.
19
COMPONENT
MAINTENANCE SCHEDULE
Rinse and air-dry every 3 months under normal use�
Empty each time you vacuum�
Pre-Motor Foam Filter
Dust Cup
Rinse and air-dry every 3 months under normal use�
Pre-Motor Felt Filter
Clean once every 2 years or as needed�
Post-Motor HEPA Filter
1
2
3
4
CLEANING THE PRE-MOTOR FILTERS
1
Remove the dust cup�
2
Pull the 2 filters out from the top of the
motor base�
(Fig� 21)
3
Rinse the filters thoroughly in lukewarm
water until the water runs clear�
DO NOT
put the filters in the washing
machine or dishwasher�
NOTE:
The material in the filter will
discolor over time� This is normal and will
not affect the performance of the filters�
4
Squeeze out excess water and let filters
air-dry for at least 24 hours before
replacing�
DO NOT
use a hair-dryer or
other heating methods to dry�
5
Reinsert the felt filter first, then the foam
filter�
6
Reinstall the dust cup�
EMPTYING THE DUST CUP
The dust cup needs to be emptied each time
you vacuum and periodically during cleaning,
when the dust cup appears full�
1
Remove the dust cup by lifting the side
latches�
(Fig� 18)
2
Hold the dust cup over a trash receptacle
and press the bottom door release button�
(Fig� 19)
Tap gently to empty contents�
Press the door closed until it clicks into
place�
3
If needed, turn the dust cup upside down
over the trash receptacle and press the
top door release button�
(Fig� 20)
Tap
gently to remove contents�
Use a dry cloth or paper towel to remove
debris stuck to the screen filter inside the
dust cup� Press the door closed until it
clicks into place�
4
Reinstall the dust cup on top of the motor
base� Hook the two latches onto the tabs
on the sides of the dust cup and push
down to lock�
Screen
Filter
Fig.
20
Fig.
21
Pre-Motor
Foam Filter
Felt Filter
Post-Motor
HEPA Filter
IMPORTANT: Loss of suction may
occur
if foam and felt filters are not
cleaned every 3 months� Rinse filters
with water only, and allow them to
air-dry completely� Also, tap loose
dirt off filters between washes as
needed� Foam filters may appear
dirty after use – this is normal�
4
Store your vacuum cleaner safely in a cool,
dry area where it will not be a hazard�
NOTE:
Empty dust cup after cleaning and
prior to storing� See Maintenance section
for instructions�
