8
Product Version 1.0 | Revision A | Released 2023-01-10
SGM offers three brackets for installation of VPLs: The
touring bracket for temporary setups and single or dual
bracket for permanent installations.
The VPL Touring Bracket (P/N: 83060633) (see figure 2) is
perfect for temporary installations. It has a snap-on sliding
bracket for quick release and easy setup, designed as a
versatile item to attach a generic third-party clamp for
rigging the VPLs. When using touring brackets, always
secure every VPL with a safety wire, attached to the
fixture's highest point.
The choice of permanent installation brackets depends on
the VPL setup.
Figure 3: Single bracket
Figure 4: Dual bracket
Figure 2: VPL Touring Bracket
The Single Installation Bracket (P/N: 86060634) is
intended for single ends of VPLs, arranged in a
parallel array (see figure 3)
RIGGING PROCESS USING SGM BRACKETS
Single Bracket
Dual Bracket
The VPL Dual Installation Bracket (P/O: 83060635) is
intended for installing the fixtures in a physical series
connection (see figure 4). The VPL Dual Installation
Bracket will maintain the pixel pitch of 20mm and can be
used in combination with the touring bracket to ensure a
consistent distance between pixels.
PLEASE NOTE! UNDERSTANDING AND CHOOSING THE RIGHT BRACKET IS CRUCIAL FOR SAFETY. FOR PERMA-
NENT INSTALLATIONS, THE VPLS SHOULD ALWAYS BE MOUNTED WITH AT LEAST TWO BRACKETS.
ALWAYS SECURE EVERY VPL WITH A SAFETY WIRE WHEN USING THE VPL
TOURING BRACKET.
