35
Product Version 1.0 | Revision A | Released 2022-4-21
CLEANING
SGM fixtures with IP65 or IP66-rating do not need any cleaning procedures inside the fixture. However, cleaning the
front lens may be needed to achieve the maximum light output after exposure to dust, sand, or dirt. The exterior
housing can also be cleaned to get a better look. To maintain adequate cooling, fans must be cleaned periodically.
Whenever necessary, clean the fixture using a soft cloth dampened with a solution of water and a mild detergent. Do
not use products that contain solvents, abrasives, or caustic agents for cleaning, as they can cause damage to hard
-
ware, cables, and connectors.
The level of cleaning required will vary greatly depending on the operating environment and installation. Therefore, it
is recommended to do frequent check-ups the first few weeks of operation to see how often cleaning is necessary.
MAINTENANCE SCHEDULE i-6
MAINTENANCE NOTES
•
In rough service environments such as with dust or fog/haze media in the air, inspect fans every 6 months at
minimum.
•
If any part is cracked, no matter the size, contact SGM Support.
ITEM
MAINTENANCE
Keypad and surrounding seal
Inspect each year.
LED engine fans and screws1
Inspect and clean each year.
DMX and power connections
Inspect every other year starting at year two.
Outer surfaces, hardware, gaskets2
Inspect each year.
Outer glass
Clean as needed.
