23
Product Version 1.0 | Revision E | Released 2023-01-11
USER INTERFACE
The G-7 Spot can be set up by using the control panel located
in the yoke of the fixture or through RDM. After powering on,
the G-7 Spot boots and resets. The current DMX start address
and any status messages will be displayed thereafter. Navi-
gate the menus and options using the arrows, and select
items using the ENTER button.
PLEASE NOTE! IN POI VERSIONS THE DISPLAY IS REPLACED
BY AN INDICATOR LIGHT. THE ADJUSTMENTS ARE MADE
THROUGH RDM. SEE “POI PERMANENT OUTDOOR INSTAL-
LATION” FOR MORE INFORMATION.
WIRELESS INDICATOR(A)
Indicates connection with a wireless transmitter.
FIXTURE NAME(B)
NEXT DMX ADDRESS (C)
Shows the next available DMX address depending on the
fixture's DMX footprint.
DMX ADDRESS (D)
Displays the current DMX address. The DMX address will flash if an address has not been set. Select DMX address
using the arrow buttons.The DMX start address is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned its own control channels. If you give two fixtures the same
address, they will behave identically. Address sharing can be useful for diagnostic purposes and identical control.
DMX MODE (E)
Displays the current DMX mode.
USING THE KEYBOARD (F)
• Press the ‘ENTER’ button to access the menu or make a selection.
• Press the arrow buttons to scroll up and down in the menus.
• Press the ‘ESC’ button to take a step back in the menu.
1
STANDARD
SGM G-7 BeaSt
DMX
(22)
D
E
C
F
A: Wireless indicator
B: Display
C: Next fixture address
D: DMX Address
E: DMX Mode
F: Keyboard
A
B
Figure 19: Control panel view
