12
Product Version 1.0 | Revision E | Released 2023-01-11
WARNING! ALWAYS SECURE AN ELEVATED G-7 SPOT WITH A SAFETY WIRE
Fasten a safety wire (not shown) between the load-bearing support structure and the safety wire attachment point
on the device. The safety cable (not included in the package) must:
• Bear at least 10 times the weight of the device (SWL).
• Have a minimum gauge of 4 mm.
• Have a maximum length (free fall) = 300 mm (12 in.).
CAUTION!
ALWAYS USE A SAFETY WIRE OF A GRADE AISI 316 STEEL.
MAKE SURE THE SLACK OF THE SAFETY WIRE IS AT A MINIMUM.
NEVER USE THE YOKE OR THE CARRYING HANDLES FOR SECONDARY ATTACHMENT.
MAKE SURE THE SLACK OF THE SAFETY WIRE IS AT A MINIMUM.
NEVER USE THE YOKE OR CARRYING HANDLES FOR SECONDARY ATTACHMENT.
Figure 5: Safety Wire attachment point
The G-7 Spot can operate on any 100–240 V, 50/ 60Hz AC mains power supply.
The maximum power consumption is 480 W.
Connect the fixture to AC power by using the supplied power cable (fig.6)
with IP connector or similar with a maximum of 20 A, to ensure the correct
ingress protection (IP rating).
The fixture must be grounded/ earthed and able to be isolated from AC
power. The AC power supply must incorporate a fuse or circuit breaker for
fault protection.
POWER REQUIREMENTS
The fixture must be grounded/
earthed and be able to be isolated
from AC power. The AC power
supply must incorporate a fuse or
curcuit breaker for fault protection.
Color
Black
White
green/yellow
Conductor
live
neutral
ground (earth)
Symbol
or
L
N
Wire
Figure 6: Power cable
