SGM G-7 BEAST, User Manual

Page: 15 / 27

15
Factory default
When restoring factory defaults at: SETTINGS → FACTORY DEFAULT, the following settings will be set:
• DMX address = 1
• Start-up mode = DMX
• Display saver = Off
• Flip screen = Off
• RDM device label set to = SGM G-7 BeaSt
• Internal program reset
RDM
Supported RDM functions
The G-7 BeaSt features support for various RDM functions.
RDM (Remote Device Management) is a protocol enhancement to USITT DMX512 that allows bi-directional communication
between the fixtures and the controller over a standard DMX line. This protocol will allow configuration, status monitoring, and
management.
You will need a RDM controller to get control over the supported parameters. See the tables below for supported RDM functions.
RDM functions
To get access to all RDM functions please contact support@sgmlight.com .
PID Actions allowed Name
0x0082 GET / SET Device Label
0x0081 GET Manufacturer Label
0x00E0 GET / SET Dmx Personality
0x00E1 GET Dmx Personality Description
0x0200 GET Sensor Definition
0x0201 GET / SET Sensor Value
0x0080 GET Device Model Description
0x1001 SET Reset Device
0x0051 GET Parameter Description
0x0090 SET Factory Defaults
0x0501 GET / SET Display Level
PID Actions allowed Name
0x0500 GET / SET Display Invert
0x0400 GET / SET Device Hours
0x0401 GET Lamp Hours
0x0121 GET Slot Description
0x0120 GET Slot Info
0x0122 GET Default Slot Value
0x8626 SET CRMX Log Off
0x8633 GET / SET Enable Wireless DMX
0x8625 GET / SET FAN 0=AUTO 1=LOW
2=HIGH 3=FULL
Sensors
To get access to all sensors please contact support@sgmlight.com .
Name Sensor Type
Main PCB Temp Temperature
Head PCB Temp Temperature
LED Beam Temp Temperature
LED Strobe Temp Temperature
Pan Angle Angle
Tilt angle Angle
Wireless Signal Other
Wireless Paired Other
Name Sensor Type
Humidity Yoke Humidity
Humidity Head Humidity
Light PWM Other
Strobe PWM Other
Voltage 52 (for general power supply) Voltage
Voltage 12 (for PCB) Voltage