Step 5:
If using trekking poles, the bow pole is optional. To set the trekking
poles, start by extending them to approx. 42” in length. Wrap the Velcro
attachment, located at the end of the WebTruss wing, around the handle of your
trekking pole. Stick the tip end of your trekking pole into the ground.
(See figure 3)
Step 6:
Adjust the tension of the WebTruss by pulling or loosening the
webbing at the tension buckles (located at corners where the WebTruss
attaches to the tent body.) For maximum strength it is recommended to firmly
tension all four (4) corners equally upon setup.
Step 7:
Connect the tent body to the WebTruss via the clips attached (DAC
Twist Clips) along the top of the tent body, and attach the two (2) Ridge Clips at
the ends of the WebTruss wings to the o-rings at the top corners of the tent body.
(See figure 4)
Step 8:
Find and layout the flysheet. Note that one end of the flysheet has a
reflective tab at each corner. Match that end of the flysheet with the end of the
tent body that also has a reflective tab at each corner (I). This will ensure proper
door/vestibule alignment. Connect the Ridge Clips at the corners of the
flysheet onto the respective o-rings on the grommet tabs at each corner of the
tent body (A, B, C, D).
(See figures 2 & 5)
Step 9:
Stake out the flysheet vestibules (G, H) using the attached cord loops
and tensioners at points G & H. Adjust the tension at each corner of the
flysheet using the attached cord loops and tensioners. For maximum strength
it is recommended to firmly tension all four (4) corners equally.
(See figure 5)
Step 10:
Connect the flysheet to the WebTruss using the o-ring and doortie
connectors along the underside of the flysheet.
(See figure 6)
Step 11:
The Skyscraper 2P Tent comes with eight (8) guy lines with clam
cleats and ten (10) J-stakes. Use the guy lines and J-stakes to externally and/or
internally guy out the tent as necessary.
Bow Pole
WebTruss
(Blue)
E
F
Trekking Pole
Guy Line
Ridge Clip
DAC Twist Clip
C L I P I D E N T I F I C AT I O N
G
H
Flysheet
(Grey)
Doortie
Connector
O-ring
TENT POLE
Inside of Flysheet
STONE GLACIER // 608 W GRIFFIN DR., UNIT A, BOZEMAN, MONTANA 59715 // 406.404.0641
Velcro
Attachment
Figure 3
Figure 4
Figure 5
Figure 6
*When omitting the bow pole in this configuration, connect a guy line with clam cleat to each o-ring at the ends
of the WebTruss wings (E, F). Stake out the loop end of the guy line cord to the ground. This will be the same stake
location as the flysheet vestibules (G, H). (This step is not required if using bow pole.)
I
Reflective
Tabs
