28
│ 5 Maintenance
Note:
The device inspection must be documented on paper if the inte-
grated device inspection is switched off.
5.1.1.4 Integrated device inspection
The integrated device inspection is accessed via the
menu
(fig. 6).
The results of the device inspection are stored in the device as
a protocol.
The device inspection protocols can be accessed at any time and
read on a computer using the
GasCom
software. The software
is available at www.sewerin.com.
The
Perform device inspection
symbol appears
when a device inspection is due. It is visible in the
display until the complete integrated device inspec-
tion has been carried out successfully. If the device
inspection was completed but the device failed on
some points, the symbol will remain visible.
The integrated device inspection is switched off in the factory
settings. The integrated device inspection has to be switched on
(once only) before it can be performed.
Switching on the integrated device inspection
1. Press
Menu
.
2. Select
Settings
.
3. Enter your
PIN code
.
4. Select
System
.
5. Select
Device inspection
.
6. Select
Yes
.
7. Apply the setting with
OK
.
8. Exit the
settings
with
Back
.
