3 Energizing a pipeline
│
11
3. Press the Down key until the
Frequency list 3
view appears
(fig. 5, right image).
4. Use the arrow keys to select a placeholder to be overwritten
with an individual frequency.
5. Press the ON/OFF key. The placeholder is marked with
Edit
(fig. 4).
6. Set the desired frequency.
The frequency can be between 200 Hz - 116.000 kHz.
●
Press the arrow keys to move the cursor right or left.
●
Press the frequency keys to increase or decrease the digits.
● Press the On/Off key to finish entering the frequency. The
Edit
marking disappears.
7. Press the pulse key to activate the new frequency.
8. Press the Down key repeatedly until the main view appears
again.
3.3
Adjusting the signal strength
The signal strength can be changed in steps.
The generator is switched on. The display shows the main
view.
●
Press the Up key to increase the signal strength.
●
Press the Down key to reduce the signal strength.
The signal strength changes with each keystroke.
Notes:
Even if in the
Signal strength
display no segment is filled, the
generator still supplies power.
Observe the notes on working in the touch-safe range in sec-
