sewerin ATS 501, Operating Instructions Manual, Page: 23 / 79

16 │ 4 Operation
Fig. 10: Gas status
Fig. 11: Waiting mode
Fig. 12: Inserted device de-
tected ( here: Manual operating
mode, Device inspection menu)
Special features at start-up
Using the GasCom software you can specify that the following
additional settings are made during start-up:
● Language
1
(fig. 13)
● Gas assignment (fig. 24, right image).
The settings are made after the start images (fig. 9).
Note:
If the settings of the test set are reset to default values using
the GasCom software, the language and gas assignment must
then be reset.
1
If, after setting the language, the list of available gases is not displayed in
the selected language, the GasCom software must be used to send the
gas file again. For more information, refer to section 11.3.