System Manual – MOVITRAC® 07
139
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
General startup instructions
Startup
9
Startup
9.1
General startup instructions
Prerequisite
Correct project planning of the drive is the prerequisite for successful startup.
You can connect the motor and start the drive immediately.
9.2
Preliminary work and resources
•
Check the installation (Installation chapter)).
•
Connect the supply system and the motor. Do not connect any signal terminals!
•
Switch on the supply system.
•
Display shows
Stop
.
•
Program the signal terminals.
•
Set the parameters correctly (e.g. factory setting).
•
Check the terminal assignment which has been set (
→
P60_ (MOVITOOLS) / P60-
(display)).
•
Switch off the supply system.
•
Connect the signal terminals.
•
Switch on the supply system.
Using the IN/OUT key
: Press the key once to go further down into the menu struc-
ture (selecting functions). Press twice or use one long key press to change to higher lev-
els in the menu structure.
It is essential to adhere to the safety notes during startup!
MOVITRAC
®
07 frequency inverters are factory set to be taken into operation with the SEW
motor which is adapted to the correct power level (4-pole, 50/60 Hz).
The startup functions described in this section are used for setting the inverter so it is
optimally adapted to the motor which is actually connected and to the given boundary
conditions.
The inverter automatically changes parameter values when you perform a startup.
0
0
I
