SEW-Eurodrive MOVIPRO PHC2 Series, Operating Instructions Manual, Page: 11 / 188

2
Safety notes
Designated use
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
11
2.4 Designated use
The product is intended for installation in electrical plants or machines.
In case of installation in electrical systems or machines, startup of the product is pro-
hibited until it is determined that the machine meets the requirements stipulated in the
local laws and directives. For Europe, Machinery Directive 2006/42/EC as well as the
EMC Directive 2014/30/EU apply. Observe EN 60204-1 (Safety of machinery - elec-
trical equipment of machines). The product meets the requirements stipulated in the
Low Voltage Directive 2014/35/EU.
The standards given in the declaration of conformity apply to the product.
The systems can be mobile or stationary.
The motors must be suitable for operation with inverters.
Do not connect any other loads to the product. Never connect capacitive loads to the
product.
The product can be used to operate the following motors in industrial and commercial
systems:
• AC asynchronous motors with squirrel-cage rotor
• Permanent-field AC synchronous motors
Technical data and information on the connection conditions are provided on the
nameplate and in chapter "Technical data" in the documentation. Always comply with
the data and conditions.
Unintended or improper use of the product may result in severe injury to persons and
damage to property.
2.4.1 Restrictions under the European WEEE Directive 2012/19/EU
You may use options and accessories from SEW-EURODRIVE exclusively in connec-
tion with products from SEW-EURODRIVE.
2.4.2 Hoist applications
To avoid danger of fatal injury by falling hoists, observe the following points when us-
ing the product in lifting applications:
• The product is not designed for use as a safety device in lifting applications.
• Use additional monitoring systems or mechanical protection devices.
26596598/EN – 10/2020