SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Operating Instructions Manual, Page: 345 / 416

11
Technical data and dimension sheets
Lubricants
Operating Instructions – MOVIGEAR
®
performance
345
11.11.3 Lubricant table
NOTICE
Selecting improper lubricants may damage the gear unit.
Possible damage to property.
• Observe the following information.
Notes
• The oil viscosity and type (synthetic) that are to be used are determined by
SEW‑EURODRIVE specifically for each order. This information is noted in the or-
der confirmation and on the gear unit's nameplate.
If you use other lubricants for the gear units and/or use the lubricants at temperat-
ures outside the recommended temperature range, SEW‑EURODRIVE does not
assume liability.
The lubricant recommendation in the lubricant table in no way represents a guar-
antee regarding the quality of the lubricant delivered by each respective supplier.
Each lubricant manufacturer is responsible for the quality of their product.
• Do not mix synthetic lubricants.
• Do not mix synthetic and mineral lubricants.
• Oils of the same viscosity class from different manufacturers do not have the same
characteristics. In particular, the minimally and maximally permitted oil bath tem-
peratures are manufacturer-specific. These temperatures are specified in the lub-
ricant tables.
• The values specified in the lubricant tables apply as of the time of printing of this
document. The data of the lubricants is subject to dynamic change on the part of
the lubricant manufacturers. For up-to-date information about the lubricants, visit:
www.sew‑eurodrive.de/lubricants
25945475/EN – 04/2019