SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Operating Instructions Manual, Page: 295 / 416

10
Project planning
Drive selection data
Operating Instructions – MOVIGEAR
®
performance
295
10.2 Drive selection data
Certain data is required to be able to precisely define the components for your drive.
These specifications include:
Drive selection data Your entry
n
amin
Minimum output speed min
-1
n
amax
Maximum output speed min
-1
n
max
Highest application speed min
-1
n
min
Lowest application speed min
-1
M
max
Maximum application torque Nm
M
a
at n
amin
Output torque at minimum output speed Nm
M
a
at n
amax
Output torque at maximum output speed Nm
S.., ..% cdf Duty type and cyclic duration factor (cdf)
or exact load cycle can be entered.
Z Starting frequency; alternatively, exact
load cycle can be specified 1/h
M4, M1..M6 Mounting position
IP.. Required degree of protection
ϑ
amb
Ambient temperature °C
H Installation altitude m
10.2.1 Determining the motor data
To select the proper drive, you first need the data (weight, speed, setting range, etc.)
of the machine to be driven.
This determines the torque and the rotational speed. Refer to the documentation
"Drive Engineering – Practical Implementation, Project Planning" or the SEW-Work-
bench project planning software for assistance.
10.2.2 Selecting the proper drive
Based on the calculated values for torque and rotational speed, the suitable drive can
now be configured under adherence of any other mechanical requirements.
25945475/EN – 04/2019