SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Operating Instructions Manual, Page: 127 / 416

6
Startup
Startup requirements
Operating Instructions – MOVIGEAR
®
performance
127
NOTICE
Undercutting the minimum switch-off time of the line contactor.
Irreparable damage to the inverter or unforeseen malfunctions.
• You must observe a minimum switch-off time of 10 s after switching off the
voltage supply.
• Do not switch the voltage supply on or off more often than once per minute .
INFORMATION
• Before startup, remove the paint protection cap from the LED displays.
• Before startup, remove the paint protection film from the nameplates.
INFORMATION
• To ensure fault-free operation, do not disconnect or connect signal cables during
operation.
6.2 Startup requirements
The following requirements apply to startup:
• You have installed the device correctly both mechanically and electrically.
• You have performed a correct project planning for the device.
• Safety measures prevent accidental startup of devices.
• Safety measures prevent danger to persons or machines.
Required hardware components:
• PC or laptop with USB or Ethernet interface, see the chapter "PC connection".
Required software:
• MOVISUITE
®
standard engineering software from SEW‑EURODRIVE.
25945475/EN – 04/2019