SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Operating Instructions Manual

Page: 85 / 416

5
Electrical installation
Plug connectors
Operating Instructions – MOVIGEAR
®
performance
85
Using third-party cables with plug connectors
If third-party cables are used – even if these cables are technically adequate –
SEW‑EURODRIVE does not accept any liability and cannot guarantee unit properties
or functions.
When using third-party cables to connect the device and/or device components, make
sure to comply with all applicable national regulations. Note that the technical features
of the unit or system of units might be affected inadvertently when using non-SEW
cables. This concerns in particular the following properties:
• Mechanical properties (e.g. IP degree of protection, cable carrier suitability)
• Chemical properties (e.g. silicone and halogen free, resistance to substances)
• Thermal properties (e.g. thermal stability, increase in unit temperature, flammabil-
ity class)
• EMC behavior (such as interference emission limit values, compliance with inter-
ference immunity values stipulated in standards)
• Functional safety (approvals according to EN ISO 13849-1)
Third-party cables not explicitly recommended by SEW‑EURODRIVE must meet at
least the requirements of the following standards and have been permitted according
to these plug connector standards:
• IEC 60309
• IEC 61984
25945475/EN – 04/2019