SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Operating Instructions Manual, Page: 54 / 416

4
Mechanical installation
Shaft-mounted gear unit with TorqLOC® (customer shaft with contact shoulder)
Operating Instructions – MOVIGEAR
®
performance
54
11. Tighten the screws of the shrink disk only hand-tight and ensure that the outer
rings of the shrink disk are parallel.
// 0.006 x D A
A
Ø
D
18014420038463755
12. Tighten the locking screws by working round several times from one screw to the
next (not in diametrically opposite sequence).
ð
The exact values for the tightening torques are shown on the shrink disk.
> 0mm
18014420038466187
13. After installation, make sure the remaining gap s between the outer rings of the
shrink disks is > 0 mm.
25945475/EN – 04/2019