SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Operating Instructions Manual

Page: 306 / 416

11
Technical data and dimension sheets
General information
Operating Instructions – MOVIGEAR
®
performance
306
11.2 General information
11.2.1 Power and torque ratings
The power and torque ratings listed in this documentation refer to mounting position
M1 and similar mounting positions in which the input stage is not completely sub-
merged in oil. In addition, the values are based on standard versions with standard
lubrication under normal ambient conditions.
11.2.2 Speed ratings
The specified output speeds are recommended values. You can calculate the output
speed based on the speed of the motor and the gear unit ratio.
11.2.3 Noise levels
All MOVIGEAR
®
units are well within the maximum permissible noise levels set forth in
ISO 8579-1 for gear units and EN 60034-9 for motors.
11.2.4 Paint
MOVIGEAR
®
units are coated with "blue-gray" (RAL 7031 according to DIN 1843) ma-
chine paint as standard. Special paintings are available on request.
11.2.5 Surface and corrosion protection
All drive units can also be supplied with special surface protection for applications in
extremely humid or chemically aggressive environments upon request.
11.2.6 Weight information
Note that all weights listed in this catalog are calculated without the lubricant fill. The
weights vary according to design and size. The lubricant fill depends on the mounting
position selected, which means that in this case no universally applicable information
can be given. Refer to chapter "Design and operating notes" > "Lubricants" for recom-
mended lubricant fill quantities depending on the mounting position. For the exact
weight, refer to the order confirmation.
11.2.7 Air admission and accessibility
When installing the driven machine, make sure there is enough space in axial and ra-
dial direction for a sufficient supply of cooling air and unobstructed heat dissipation.
25945475/EN – 04/2019