88
Operating Instructions – MOVIGEAR® DAC-B
6
Startup with binary slave GLK30A in "Expert" mode
Startup
6.5
Startup with binary slave GLK30A in "Expert" mode
6.5.1
Startup steps
In Expert mode, individual parameters can be used in addition to the basic functionality
of the MOVIGEAR
®
drive unit.
1. It is essential that you observe the startup instructions.
2. Disconnect all components from the voltage supply and use an external disconnect-
ing device to avoid an unintentional re-connection.
3. Make sure that the MOVIGEAR
®
drive unit is connected properly. Observe chapter
"Electrical Installation".
4. Startup the unit in "Easy" mode.
5. Set DIP switch S1/1 to ON to activate "Expert" mode.
6. Connect the PC to the MOVIGEAR
®
inverter.
7. Connect the MOVIGEAR
®
inverter to the voltage supply.
8. Start MOVITOOLS
®
MotionStudio and integrate the MOVIGEAR
®
inverter.
9. Specify the parameters you want to change.
10.Check whether these parameters depend on mechanical controls. See chapter
"Parameters that depend on mechanical controls".
11.Deactivate the respective controls by adjusting the bit-coded selection box of
parameter
Index 10096.30
.
12.Change the selected parameters.
INFORMATION
• "Expert" startup is only necessary if parameters are to be set during startup.
• The following chapter describes the preparations made on MOVIGEAR
®
for
activating the Expert mode and an example for fine-tuning parameters.
• The chapter "Parameterization and diagnostics" describes how you integrate
MOVIGEAR
®
in MotionStudio and contains an overview of all parameters with a
detailed description.
2444784139
ON
DIP
1 2 3 4
S2
DIP switch S2/1 = ON
Expert mode
NOTICE
Set the DIP switches using suitable tools, e.g. a slotted screwdriver with a blade width
< 3 mm.
The force used for setting the DIP switches must not exceed 5 N.
0
0
I
Summary of Contents for MOVIGEAR DAC B
Page 2: ...SEW EURODRIVE Driving the world...
Page 257: ......
