22
Operating Instructions – MOVIGEAR® DAC-B
3
MOVIGEAR
®
with optional package for wet areas
Unit Design
3.8
MOVIGEAR
®
with optional package for wet areas
3.8.1
Properties
The following figure shows the additional features of MOVIGEAR
®
drive units with the
optional package for applications in wet areas:
3.8.2
Legend
2368836235
[12]
[4]
[5]
[6]
[7]
[8]
B
B
A
A
[10]
[9]
[11]
[2]
[1]
[3]
All illustrations regarding MOVIGEAR
®
drive units with optional package for wet areas are
displayed with a shading (= HP200 surface protection) in this publication
[1]
Mounting screws for electronics cover made of stainless steel
[2] Connection ring only possible with cable outlet "at the bottom" or "on the side":
– In connection with mounting position M1 and M2: 2 + 3, 2 + X, X + 3, 2 + X + 3
– In connection with mounting position M4: 2 + X
– In connection with mounting position M5: X + 3
– In connection with mounting position M6: 2 + 3
[3]
Screw plugs made of stainless steel installed at the factory
[4]
HP200 surface protection, see chapter "Technical data and dimension sheets"
[5]
Oil screw plug made of stainless steel (hexagon)
[6] Additional cover opposite the output side
[7]
Mounting screws for gear unit housing made of stainless steel
[8]
Breather valve mounted and activated according to mounting position, see chapter "Tech-
nical data and dimension sheets"
[9]
FKM oil seal (Viton)
[10] Output shaft made of stainless steel (can be deselected)
[11] Pre-installed pressure compensation fitting (M16) with mounting positions M5, M6
[12] Pre-installed pressure compensation fitting (M16) with mounting position M1, M2, M4, M4
Optional plug connectors (see chapter "Electrical installation") are available in connection
with the package for wet areas.
Summary of Contents for MOVIGEAR DAC B
Page 2: ...SEW EURODRIVE Driving the world...
Page 257: ......
