10
Operating Instructions – MOVIGEAR® DAC-B
2
Installation
Safety Notes
2.5
Installation
The units must be installed and cooled according to the regulations and specifications
in the corresponding documentation.
Protect the MOVIGEAR
®
drive units from improper strain.
The following applications are prohibited unless the unit is explicitly designed for such
use:
• Use in potentially explosive atmospheres.
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, radiation, etc.
• Use in non-stationary applications that are subject to mechanical vibration and shock
loads as stated in the documentation for MOVIGEAR
®
drive units.
Important: MOVIGEAR
®
drive units and corresponding mount-on parts must not
protrude into footways.
2.6
Electrical connection
Working on live parts of MOVIGEAR
®
drive units is not permitted.
The drive is operated as a generator due to the kinetic energy of the plant/machine.
Secure the output shaft against rotation before you open the wiring compartment.
Electrical installation is to be carried out in compliance with pertinent regulations (e.g.
cable cross sections, fusing, protective conductor connection). For any additional
information, refer to the applicable documentation.
You will find notes on EMC-compliant installation, such as shielding, grounding,
arrangement of filters and routing of lines, in the documentation of the MOVIGEAR
®
drive units. The manufacturer of the system or machine is responsible for maintaining
the limits established by EMC legislation.
Protective measures and protection devices must comply with the regulations in force
(e.g. EN 60204-1 or EN 61800-5-1).
2.7
Safe disconnection
MOVIGEAR
®
drive units meet all requirements for safe disconnection of power and
electronic connections in accordance with EN 61800-5-1. All connected circuits must
satisfy the requirements for safe disconnection as well.
Summary of Contents for MOVIGEAR DAC B
Page 2: ...SEW EURODRIVE Driving the world...
Page 257: ......
