Manual – DFE32B Fieldbus Interface PROFINET IO
107
9
Communication SBus (CAN) via interface adapter
MOVITOOLS® MotionStudio – Operation
9.8
Communication SBus (CAN) via interface adapter
9.8.1
Engineering via interface adapter (SBus)
Since your unit supports the "SBus" communication option, you can use a suitable inter-
face adapter for engineering.
The interface adapter is an additional hardware component available from
SEW-EURODRIVE. You can use it to connect your engineering PC with the respective
communication option of the unit.
The following table shows the different types of interface adapters (options) available,
and for which units they are suitable:
To connect the PC CAN interface to the unit, you need an additional connection cable
with terminating resistor. The scope of delivery of the PC CAN interface from SEW in-
cludes a prefabricated connection cable on the unit with terminating resistor. Therefore,
only this PC-CAN interface is described in the following chapter.
9.8.2
Starting up the USB-CAN interface
Overview
This section describes how to connect the PC-CAN interface from SEW to the SBus in-
terface or your units and what must be considered for this.
CAN pin assign-
ment
The figure below shows the pin assignment of the 9-pin D-sub connector of the PC-CAN
interface from SEW (view from top):
Interface adapter type
(option)
Order no.
Scope of delivery
Units
PC-CAN interface from
SEW (incl. prefabricated
connection cable with inte-
grated terminating resistor)
18210597
•
Prefabricated cable with
9-pin D-sub connector
for connection to the
unit, length 2 m
•
A 120 ohm terminating
resistor is fitted to one
end of the prefabricated
cable (between CAN_H
and CAN_L).
•
MOVIAXIS
®
•
MOVIDRIVE
®
B
•
MOVITRAC
®
B
•
MOVI-PLC
®
(
basic
and
advanced
)
PCAN-USB ISO from Peak
IPEH
002022
•
Without connection
cable
•
Without terminating
resistor
12191AXX
Summary of Contents for DFE32B PROFINET IO
Page 2: ...SEW EURODRIVE Driving the world...
Page 131: ......
