SEW-Eurodrive CMP40, Operating Instructions Manual, Page: 31 / 88

Operating Instructions – Explosion-Proof CMP Synchronous Servomotors
31
5
Connecting the servomotors and the encoder system via SM/SB plug con-
Electrical Installation
5.9 Connecting the servomotors and the encoder system via SM/SB plug connec-
tors
The CMP synchronous servomotors are supplied with an SM/SB plug connector sys-
tem. In the basic design, SEW-EURODRIVE delivers CMP synchronous servomotors
with a flange socket on the motor end and without mating connector. The encoder sys-
tem is connected using a separate 12-pin round plug connector.
The mating connectors can be ordered separately.
5.9.1 Plug connector on the cable end
Power cable
STOP!
Route the signal cables separately from the power cables with a minimum distance of
200 mm. The cables can only be routed together if either the feedback cable or the
power cable is shielded.
Plug connector
system Cable type Type
1)
1) Fixed: fixed routing; flex: Cable carrier installation
Cable cross section Part number
SM11
Motor cable Fixed
4 x 1.5 mm
2
0590 4544
SM12 4 x 2.5 mm
2
0590 4552
SM14 4 x 4 mm
2
0590 4560
SM11
Motor cable Flex
4 x 1.5 mm
2
0590 6245
SM12 4 x 2.5 mm
2
0590 6253
SM14 4 x 4 mm
2
0590 4803
SB11
Brake motor
cable
2)
2) 3-core cable, only 2 cores are used
Fixed
4 x 1.5 mm
2
+ 2 x 1 mm
2
1332 4853
SB12 4 x 2.5 mm
2
+ 2 x 1 mm
2
1333 2139
SB14 4 x 4 mm
2
+ 2 x 1 mm
2
1333 2147
SB11
Brake motor
cable
2)
Flex
4 x 1.5 mm
2
+ 2 x 1 mm
2
1333 1221
SB12 4 x 2.5 mm
2
+ 2 x 1 mm
2
1333 2155
SB14 4 x 4 mm
2
+ 2 x 1 mm
2
1333 2163