41
SESAMO
DUALCORE
Manual release
For safety reasons, the electric door lock device is equipped with a manual release control. It is
supplied and installed as follows:
Lever release: the release is obtained by acting on the special lever handle installed near the
system or on one of the automated system heads; by acting on the release handle it allows the
manual movement of the leaves. By resetting the handle to its initial position, the doors will be
locked by the electric lock.
The release mechanism must be checked periodically to prevent loosening, dirt, wear,
corrosion or other unexpected causes that could hinder its correct operation.
Electronic key/key selector
Using this accessory together with the electric lock device, it is possible to close the leaves
from outside the room, regardless of the logic selected on the basic or advanced selector. Any
lack of mains following this closure will not cause the opening of the doors
Each time the electronic key is inserted, the automated system switches from normal
operating condition to locking condition in closing mode and vice versa. During the transition
from locked to normal operation, the leaves perform a complete opening and closing
maneuver in order to allow a person to enter.
Operation in the absence of mains with batteries installed
Panic mode: when there is no mains voltage, the leaves go into stop open. The doors can be
closed using the closed stop function on the selector or using the RD100 selector key.
Continuous operation mode: in the absence of mains, the automated system continues to
operate with the logic reset until the batteries are low.
The choice of the type of operation is carried out during installation by a qualified technician.
For the RD100 version, where the batteries are always present as an integral part of the
security system, the only possible mode is panic mode.
Cleaning and maintenance
Object
Mode
Painted surfaces
Clean with soap and water
Anodized surfaces
Clean with water and non-alkaline soap (pH 5.5/7)
Selectors
Clean with a damp cloth
Summary of Contents for DUALCORE LH100
